Warning: Illegal string offset 'calendardate' in /home/cbjdigital/sites/www.wateractive.co.uk/scripts/script-products.php on line 4
Water Active :: products :: Clean water pump for rainwater harvesting tank

Latest product launches

Clean water pump for rainwater harvesting tank

Posted: Thursday 1st March 2012

Intensive design and development and exhaustive testing have brought about one of the highest quality pumps available on the market and the only one manufactured in the UK. With the strapline ‘quality under pressure’, the new HydroForce pump has been designed with a number of important features.

Perhaps the most important of these is the alloy bulkhead, pressure release gap and twin chamber design which prevents ingress of water to motor, electrical components and to bearing oil, and for which a patent has been applied for.

Other key features are that it is pressure sensitive (it turns itself off until there is a demand for water); it’s dry-run protected (it turns itself off when no water is detected); and it comes complete with factory fitted filter, connectors and non-return valve.

British manufactured in Peterborough with Italian styling, the new HydroForce pump provides a high quality solution for all those involved in rainwater harvesting from equipment providers and merchants to developers, contractors and water pump distributors. It is guaranteed for two years and satisfies a need for a pump with good performance and reliability where other pumps have seen high percentage failure rates.

Individually tested and automatically logged for quality on the production line, the HydroForce pump has an impressive technical specification. The new pump can be fully immersed in tank water or it can be externally connected to the tank above ground. The pump will deliver up to 3.5 bar and delivers over 2,500 litres per hour using a one-inch connector. Rated at 800w, on a 220v to 240v power supply, the pump is electronically controlled and features logic processors in the printed circuit board (PCB).

The dry-run protection design is one of the best available. If no water is detected for eight seconds the pump is turned off by the PCB so as to protect the motor and pump from burning out. There is an automatic re-set after a period of 30 minutes. If water is still not detected, the subsequent re-set periods are one and a half, three, seven, twelve and twenty-four hours and then back to the beginning of the cycle. Additionally, a thermal switch not connected to the PCB turns the pump off if the motor should overheat and re-sets when it’s cool again.




Read the magazine online

October 2017

About the magazine »
Magazine archive »


Advertisements

Information for advertisers »

Sykes Pumps
Huber Prominent Fluid Controls British Water Pulsar Button June 13 Metasphere Button Lutz-Jesco Verder Harvey Communications Water Aid wateractive
ATI UK